WeDo Rabbit

• 2×Lime Plate 4 x 6 without Corners

Lay the two lime 4x6 plates front to back to make a 6 x 8 meadow.

Step done

• 2×Bright Light Orange Technic Plate 2 x 6 with Holes

Put the two orange Technic plates side by side, running front to back, in the middle of the meadow with one row free in front. They are the rabbit's long back feet.

Step done

• 6×White Plate 1 x 2
• 2×Bright Light Orange Slope Brick 33 3 x 1

Put an orange slope on each outer corner at the front, sloping down toward you: they reach one stud past the feet. Between them stack three layers of two white 1x2 plates.

Step done

• 2×Bright Light Orange Brick 2 x 4

Two orange 2x4 bricks across the feet, right behind the paws. They lock the feet together.

Step done

• 2×Bright Light Orange Brick 2 x 4

Put one orange 2x4 brick across the front, over the paws and chest. Put the last one in the middle behind it, running front to back: it sticks out one stud past the body.

Step done

• 2×Bright Light Orange Slope Brick 33 3 x 1
• 1×White Plate 2 x 2 Round with 1 Centre Stud

Fill the back corners with the last two orange slopes, sloping down toward the back. Press the white round plate onto the end of the middle brick as a tail.

Step done

• 2×Bright Light Orange Technic Plate 2 x 4 with Holes

Stack two orange Technic plates 2x4 on the front brick.

Step done

• 3×White Plate 1 x 4
• 2×Light Bluish Grey Brick 1 x 2 with Pin

In the front row stack three white 1x4 plates. In the back row put the two grey bricks with pins, pins pointing backwards.

Step done

• 1×Bright Light Orange Technic Plate 2 x 4 with Holes

One more orange Technic plate 2x4 holds the head together.

Step done

• 2×White Bracket 1 x 2 - 2 x 2 Down
• 2×White Tile 1 x 1 Round with Eye Pattern
• 1×White Plate 2 x 2 Round with 1 Centre Stud
• 1×Black Plate 1 x 1 Round

Hang the two white brackets over the front edge so their studs face forward. Press the eye tiles onto the top outer studs, the white round plate onto the middle four, and the black round plate onto its centre stud as the nose.

Step done

• 2×Bright Light Orange Technic Plate 2 x 6 with Holes

Push an orange Technic plate 2x6 onto each pin by its end hole, studs facing back: the left ear close to the head, the right ear at the end of its pin. Tilt them apart into a V.

Step done

• 2×Bright Green Plant Grass Stem
• 2×Dark Bluish Grey Tile 2 x 2 Round with Hole
• 1×Bright Green Plant Flower 2 x 2 Leaves
• 1×Red Plant Flower 2 x 2 with Solid Stud

Put the green leaves and the red flower in front of the rabbit's nose, between the paws. The grass stems have a stud underneath, so they need a hole: press the two dark grey round tiles onto the outer edge of the meadow, half hanging over the side (front left and back right), and push a grass stem into each tile's hole.

Step done